TUFFSIDE "universal" frame hoops (Made in house!)
With USA STEEL!
- 1" tubing 8" outside to outside*
- 1" tubing 9" outside to outside*
- 7/8" tubing 8" outside to outside*
Upswept hoops are bent about 20degrees at 5.5"- 6" back from the rear of the hoop.
You can spread the hoop open a bit to fit your project by standing on one side and pulling the other (if you're strong enough), or putting it in a vise and prying it open or closed with another piece of tubing for leverage.
These will fit our FLAT seats just about perfectly - but depending on your frame width some modification may be needed. *Outside to outside measurements are 'approximate' and may vary slightly on some frame hoops.
Cafe racer seats have a "V" shape at the back, Please see our "Cafe hoops" section for cafe style seat hoops.
These hoops are a little longer than needed so you can trim the excess off the ends to match your project.
Universal hoops are a "starting point" for your build only. May need to be cut, bent, modified etc.. to fit your project.
As with ALL custom products these are not meant to directly "FIT YOUR BIKE" some modification may be required